A custom-shaped hot sauce bottle blimp flying over a college basketball crowd.
Indoor & outdoor RC blimps · Made in USA

Your idea. Our experience.

Proud partners withAerostar International and Airworks Enterprises

Ripped Blimp?

BLIMPWORKS specializes in repairing tears for indoor and outdoor blimps. Call Scott Fisher.

414-305-3145
Blimp repair kit

Repair kits

Repair kits are standard equipment with all sizes of blimps. We use the exact nylon material your blimp is made of, and the glue is included. Refer to your owner’s manual for recommended repair procedures.

Blimp envelope on the repair bench

Envelope repairs

Small repairs are easy to make on location so you don’t miss any part of your flight. A small repair, a cut no larger than 12 inches, takes just a few minutes and will hold well if applied properly.

If the slice or hole is larger than 12 inches, call Scott Fisher at 414-305-3145 for advice. You may have to send the envelope back to the factory.

Blimp fin assembly

Electronic and fin repairs

If you think your electronics flight package, transmitter or fin package needs repair, contact Scott Fisher at 414-305-3145 for troubleshooting and possible replacement. Make sure all batteries are fully charged first, including the one in your transmitter.

Blimp fan and motor

Fan and motor repairs

It is rare that we have problems with our equipment, but sometimes it happens. Try troubleshooting with fully charged batteries first. If that does not work, contact Scott Fisher at 414-305-3145. Service hours are from around 8:00 am until 10:00 pm Central time.

Inflating a nylon blimp

Inflating your blimp

Inflating your nylon blimp is a simple process. Your blimp came with an inflation hose and pressure gauge; have both out and ready to use. The pressure gauge should show around 1.2 inches of water. Watch the videos in the side panel.